Took me 5 hours but I was able to do it.
If you’re having trouble getting the tubes connected with the barb splicer, you can reach up from the bottom and push them together. That’s what I had to do. I used rubber surgical gloves but they kept getting cut off with the sharp edges.
Parts
- Motorcraft 75W140 Synthetic Gear Oil Fluid Rear Axle Lubricant Ford OEM https://amzn.to/3wMZzij (buy 3-4 for cheaper)
- EDGE INDUSTRIAL 5/16″ Hose ID Brass Hose Barb SPLICER Union Fitting Fuel / AIR / Water / Oil / Gas / WOG (Qty 1) https://amzn.to/3kQZxmP
- FloTool 10111/6 Mixmizer Injector https://amzn.to/3YfYtr5
- uxcell Silicone Tubing 5/16″(8mm) ID X 1/2″(12mm) OD 3.3ft(1m) Silicone Rubber Tube Air Hose Pipe for Pump Transfer Black https://www.amazon.com/dp/B07R64J4H9?…
- Permatex 59214 High Temperature Thread Sealant, 6 ml Tube, Pack of 1 https://amzn.to/3HstXUj
- Norpro 4-Cup Capacity Plastic Measuring Cup x 2 / or go to grocery store/walmart https://amzn.to/3RsRRmU
- Permatex 25219 Fast Orange Pumice Lotion Hand Cleaners, Citrus, Bottle with Pump, 1 gal https://amzn.to/3wLskMu
- OR SMALLER ONE Permatex 25108 Fast Orange Pumice Lotion Hand Cleaner, 7.5 oz. https://amzn.to/40nJnBJ
- Jack,
- Jackstands x 2,
- Giant cardboard box flattened to catch the oil
- Allen Wrench(s) (until you find the right one)
- step stool, old towel to lay over the front of engine,
- sparkling water / cup of ice for it
- headlamp led if at night